FLEXIBLE MANUFACTURING TRAINER MODEL IBL-31

Product Code: PCI004

Description: This is a flexible manufacturing system trainer. This can be used with PLC trainer also. This trainer provides very good scope to understand how automation process can be designed. The purpose of the system is to sort out the wooden pieces and metal pieces, which are moving on a conveyor belt by a program. In order to facilitate this, the following systems are built into the system. a) There are two 12 inch conveyor belts. Each belt moves in the opposite direction of the other belt. b) Two programmable pneumatic pistons with 5 inch travel. c) Optical source to detect either metal or wooden moving parts on the conveyor belt when the light beam is cut. d) A metal detector transducer to detect the metal part moving on the conveyor belt. e) An external compressed air at 5Kg/cm2 is required to activate the pistons. In order to accomplish this task, the flexible manufacturing systems is used. For that we need belt conveyor, which is driven by a motor in which the test piece & other piece will move. In order to sort out the metal piece we need a PROXIMITY transducer & OPTICAL transducer and piston to push the pieces for further rotation. Piston is basically a hydraulic one for that we need a compressor to actuate the piston to move the Test piece forward for further rotation. Principle of Operation: The test piece (both metal & wooden) will move through belt conveyor driven by a motor in the system. First, the test piece will pass through the OPTICAL transducer and basic principle of transducer is whenever light from the source is obstructed by any object it goes to high state. If any test piece obstructs the light path to transducer from the source, gives signal to piston & piston will move the test piece for further rotation Once if test piece get passed through the optical transducer it will enter in to PROXIMITY transducer. Principle of proximity transducer is normally it is in high state. Transducer will differentiate the metal piece from the other pieces. Range of detection is about (0 - 5) mm. If it is above the range transducer will not detect metal parts.